10/100 Mbps Ethernet IP Core for FBGA

$250-750 USD

Zaprt

Objavljeno

pred približno 4 leti

$250-750 USD

Plačilo ob dostavi

FBGA part number : XC7A200T-2FBG676I 1 - Complete 10/100 Mbps Ethernet IP with all the necessary IP modules for FBGA. Ethernet FPGA IP core must consist of a 10/100Mbps Ethernet media access control (MAC) and physical coding sublayer (PCS) intellectual property (IP). This IP function must enable FPGAs to interface to an internal Ethernet PHY device, which interfaces to the Ethernet network. This IP must be offered in MAC+PHY mode. 2 - Sending Data buffered in the RAM [over AD9371] via Ethernet to MCU Please see the pictures the following

Electronics

Microcontroller

C Programming

Electrical Engineering

PCB Design and Layout

ID projekta: 24248026

Več o projektu

3 ponudb

Projekt na daljavo

Aktivno pred 4 leti

Želite zaslužiti?

E-naslov

Prednosti oddajanja ponudb na Freelancerju

Nastavite svoj proračun in časovni okvir

Prejmite plačilo za svoje delo

Povzetek predloga

Registracija in oddajanje ponudb sta brezplačna

3 freelancerjev je oddalo ponudbo s povprečno vrednostjo $552 USD za to delo

@Manoj3050

Hi, I am an FPGA engineer with 5 years of experience in FPGA based systems development, specifically Ethernet related. I have worked on 1Mbps/10Mbps 100Mbps as well as 100Gbps Ethernet solutions and have developed IPs for MAC and PCS layer as well. I also have an IEEE paper based on this. I think you are using Xilinx Arty FPGA device, but I am not sure of SFP ports in it. Anyway at 100Mbps, you dont need SFP ports. I would like to discuss more on the project. Looking forward to hearing backf rom you. Thank you Anusha

$600 USD v 20 dneh

4,8

(42 ocen)

5,9

@dhameja15

I am interested in your project and I am free to start now. I will need the schematic diagram or the circuit diagram. I will mail you the Altium project.

$500 USD v 7 dneh