Schematic PCB design, ready to manufacture gerber, centroid and bom -- 2

First, view the PDFs attached before making a proposal, those who do not will be ignored. Persist, and profile will be reported. Freelancer becomes a waste of time due to spamming from South Asia groups.

Adapter board:

Very simple.

Convert my 3d/2d layout to a pcb.

A simple schematic and pcb layout.

Get the grounds right!

Componet part numbers are provided, again, on the pdf.

Keep the video trace clean - signal clarity and low latency are key.

Optional: Filter 5v (bec supply) between M2 to C1

Optional solder pad to take 5v M2 -> to 12v -> to C1 if possible.

Note:

The main power is 3s or 4s lipo at V1.

Secondary power is sent from M2 to C1 This why there must be proper grounding.

Second:

4 simple LED using audrino pixels.

The control is on the main board. These need to be traced in ribbon fashion. Should be obvious to those with experience.

The winning Proposal will be for $100 for manufacturing files, gerber, schematic, centroid and BOM.

We will immediately run them at oshpark and solder the first ones by hand.

Everything works and another $100 will be sent.

This won't take a skilled EE a day to finish.

Oblikovanje tokokrogov Elektro inženiring Oblikovanje tiskanih vezij v PBC

ID projekta: #11092273

Več o projektu