Need support in figuring out how to control reversible motor to open and close rotating door.

Končano Objavljeno pred 4 letoma/leti Plačilo ob prevzemu

$10-30 USD

Plačilo ob prevzemu

Končano Plačilo ob prevzemu

I have a large rotating package passage that allows the ability to insert an item, rotate the drum 180º to allow the customer to remove the item. Also the same movement of items in the reverse direction.

So the motor needs to be able to rotate a specific number of times and then stop in the with the correct alignment of the drum. Then we need to allow the reverse of that a specific number of rotations to original position. I have read about STEPPER MOTORS and possible something to control the count of steps from 0º to 180º.

The original motor was a 1500 rpm motor 115V and .48 amps. the model is 4RJ20GA-AA and I have just bought a used one but will buy a new Stepper motor if needed.

I think I need help in sourcing the correct hardware and to know what controls it.

Elektro inženiring Elektronika Inženiring Strojni inženiring Mikrokontroler

ID projekta: #24520240

Več o projektu

5 predlogov Oddaljen projekt Aktiven pred 4 letoma/leti

Želiš zaslužiti nekaj denarja?

Prednosti oddajanja ponudb na Freelancerju

Nastavite svoj proračun in časovni okvir
Bodi plačan/a za svoje delo
Oriši svojo ponudbo
Vpis in prijave na dela so brezplačni

Dodeljeno:

Profilna slika binyameen441
binyameen441

There is no need to look elsewhere. You will get quality work in minimum budget and time. You can have a look at my profile and portfolio. Thanks

$20 USD v 7 dneh
(125 mnenj)
6.7

5 freelancerjev ponuja v povprečju za $19 na tem delu

Profilna slika v8volante
v8volante

Hello, allow me to suggest rotating the drum only in one direction. Place a switch (interrupter) somewhere on the circumference. On the drum there are two notches 180 degrees apart to activate the switch. On the push o Več

$20 USD v 7 dneh
(3 ocen)
4.2
Profilna slika nikvk
nikvk

I may have some ideas for this project.

$25 USD v 1 dnevu
(0 ocen)
0.0
Profilna slika andersenf
andersenf

I am specialized in servo motors and variable frecuency controls. Ill develop the drive configuration whith the HMI if you needed

$20 USD v 7 dneh
(0 ocen)
0.0
Profilna slika EngrBilalMunir
EngrBilalMunir

I am interested in your project. Hope that you will consider me for this project. Skills 1. Arduino 2. Digital Logic Design 3. C++ 4. Trouble Shooting 5. Circuit Design

$10 USD v 3 dneh
(1 Ocena)
0.0
Objavi podoben projekt