Objava natečaja

3D Design of USB Thumb Drive Enclosure

Stanje: Closed
Nagrade: $200
Prejetih vnosov: 11

Navodila natečaja

The USB thumb drive is not an ordinary storage drive but a security device with some high-security features built in. The goal is to design an appropriate enclosure which reflects the necessary "trust" and "robustness" and at the same time has a unique note.

The size of the device is about 18 x 23 x 6.5mm with an ordinary USB plug at the end. A small size of the enclosure is important which is why the design should not bloat the size too much.

The enclosure will be made out of plastic and should be easy to manufacture. Hence, no super special constructions please.

It contains of:
- Two parts: the main enclosure and the lid for the USB plug
- A hole for a key ring
- A LED

The design must be provided in source files (of whatever application) and exported in IGS file format.
Optional: It would be preferred to get the source files in a format of an open source software.

Priporočene spretnosti

Objavi podoben natečaj

Javna tabla za pojasnila

gonzacu
- pred 11 let
Is just what I did. In my designs, #6 #7 #8 ,the main body size is 18 x 23 x 6.5mm without the plug. And the cap size is 11.5x18x6.5 including the plug. Thanks
- pred 11 let
vw8053922vw
- pred 11 let
i alredy make the mesurement 18x23x6.5mm for the main body only , not for the body and the usb plug
- pred 11 let
Nosilec natečaja
- pred 11 let
For clarification: The size 18 x 23 x 6.5mm is of the main body without the USB plug. So the USB lid would be an addon to this size.
- pred 11 let