SMD PCB DESIGNING & SUPPORT

Hello. Thanks for sharing your project. I am an experienced electronics engineer expert in PCB designing and embedded systems. I can complete your project in minimum time and at minimum cost. I am ready to start working from right now. I will keep good communication. Waiting for your reply. With regards, Harsh Sharma

Hello, please let me know your requirements and also your location. I will be able to do the design which is required and also help in manufacturing and assembly of the PCB. I have 10+ years experience in the same. Looking to hear from you

Dear Sir, I am Electrical Engineer, many years of Firmware development, circuit design, PCB design experience. I have used Altium Designer for many years, designed many PCBs, single layer, multi layers, RF circuit, Bluetooth, Wi-Fi, Microcontroller etc.… This includes schematic capture. I can perform circuit simulation and confirm functionality. I can start working on the project immediately. The work performed is guaranteed. Please contact me and we can discuss the project. I can visit your office, please provide location. How many hours per week? Can I complete the project and then visit your office for presentation? Thank you Sincerely, Jatin Mehta

I am a Research Assistant in IIT Bombay. I have been working in electronics embedded hardware industry for the last 4 years. I am a teacher/trainer for PCB designing. I use the following softwares: Orcad Layout, Orcad Allegro, Kicad, Cdsoft Eagle and Altium. I have made upto 10 layers of PCBs till now. Compact PCB's are my speciality and I assure you that once the PCB is brought up, it is a sure shot to work. None of the PCBs made with my recommendations have ever failed. Embedded, High Power, RF and DSP based circuits are some of the domains where I have worked in. I don't know where your office is, but even if I am not able to visit, I am pretty sure we are able to work thigs out over a video call, be it Skype or WebEx.

Where are you located? I have experience with SMD components. Please share more about details about the project.

Document Properly Provied

Dear Sir, I have experience in field of PCB designing of more than 10 years. I am well familiar with eagle and altium. I have designed boards for microcontrollers, microprocessor, FPGA and APSOCs. I have experience in designing multi layer boards and has worked up to designing 12 layers of PCB. I can be available for work for 50 hours a week. looking forward to work with you.

iam pcb designer using allegro.i did about 70 boards using smd components.I want to do it. can u say location

I have been designing PCB since 2016 in Proteus, Orcad and sprint Layout. I have designed PCB for Stm32f407 and Sensors MPU 6050 and SD card module connected with stm32. I like designing. I can show my work.