I want to build Water level indicator using Ultrasonic sensor "JSN-SR04T-2.0". This is water proof type sensor as shown below.
I want to use STM32F103 "Blue-Pill" board as shown below.
The Water tank is 5 Ft in height and water is filled in it upto 4 Ft. The sensor will be fitted at the top inside the tank.
I need to use 4 LEDs to glow to show the water level at each 1Ft height.
The firmware is needed in Truestudio/CubeMX. Lots of sample codes for various MCU's are available for this type of US sensors for ranging as well as water level measurement. So it will not be a difficult task.
I will do advance upfront payment before the start of work so that you can deliver it as quickly as possible. The project cost is fix $10 only.
10 freelancerjev ponuja v povprečju za $24 na tem delu
I have experienced in Embedded Systems. I have worked on Arduino, ESp32 boards, MSP430, RaspberryPi, Beagbone. I have knowledge of wireless communication. I can work with your project. Please contact with me!
Hello, I have experience in firmware writing for the different microcontroller family. I can finish this job for you. Let me know if you have any questions for me! Thanks, Vatsal