Schematic design/capture, component footprint and component pattern entry for board-on-board module w/Ethernet.

Work Required ============= Design the circuit schematic, associated component schematic symbols, and component footprints for a small system-on-module. The design will be used for a board-on-board module. The module includes an on-board Ethernet RJ45 jack. The work will be performed using the EDA software DipTrace 3.3 or newer. PCB layout is excluded from the scope of work. The designer will choose the additional components needed from DigiKey and/or Mouser. All components must be listed in Active production and order-able in quantities <= 500 from one of them. This is a minimal design. It should only include the components necessary to power and run the V3s booting off of a microSD card that will be soldered to the PCB, and operate the Ethernet interface. All signals not used for this functionality shall be connected to pads defined in a footprint that will be placed at the edge of the PCB. Deliverable ============ 1. Circuit component schematic in DipTrace 3.x .dip format. 2. Library of custom designed component schematic symbols attached to footprints in DipTrace 3.x .eli format. Module Specifications ===================== Power Input Single 5V Filtered DC SoC Allwinner V3s - 120-pin LQFP Information on the Allwinner V3s SOC, including data-sheet is available at: [login to view URL] Sample schematic is available at: [login to view URL] 100 Mbps Ethernet - The Allwinner V3s contains the Ethernet Controller and PHY Interface RJ45 Connector - SMD w/ LEDs, Yellow on Left, Green on Right RJ45 network socket 56 + LED / with shielded horizontal patch with light, SMD Discrete Magnetics LINK-PP LP82440ANL Gigabit ultra-thin single-port network transformer filter Equivalent to Pulse H5084NL Equivalent to HQST H82409S Voltage Regulator EA3059 24-pin QFN 4x4 [login to view URL] 3 outputs used 1.2V, 1.8V, 3.3V Storage MicroSD Card soldered-down This is the SoC's boot device. (Foot-Print design is also needed for this.) Crystal ECS ECS-240-8-33Q-JES-TR 24MHz 20ppm 8pF -40C +125C SMD 3.2x2.5mm