We have an LCD with an LVDS interface that we want to drive from an ARM board with 24-bit parallel LCD interface. The board runs on 3.3V for logic levels and power supply.
The display uses offset voltages of +20V, -6.8V, +11V that need to be generated.
The backlight consists of on string of LEDs that need to be driven at 9.6V with 160-180mA.
The parallel RGB input comes from a 40 pin, 0.5mm pitch FPC with typical control signals, the LVDS ouput is another 40pin0.5mm pitch connector. The full LCD datasheet is available if you're interested in this project.
A number of components that might be used:
* [login to view URL] for the lvds conversion
* [login to view URL] for voltage generation
plus an LED driver chip.
Outcome of the project would be either a Kicad or Eagle project with component library plus the corresponding Gerber files.
7 freelancerjev ponuja v povprečju za €146 na tem delu
Hi, I read your job posting carefully and understood it. I am good at Altium designer and kiCad. Please contact me. I would complete this project with great production. Regards.