Arduino cpp code for SPI communications with ADCs and digital potentiometers
$30-250 USD
Plačilo ob prevzemu
Need to continue this initial OO code that loads on a Due board and will have to set via SPI the individual values of 24 digital potentiometers (Analog Devices AD5174BCPZ-10-RL7) and to read, also via SPI, data from 3 ADCs (Analog Devices AD7689BCPZRL7) each with 8 channels.
The Arduino Due uses 4 digital ports (23, 25, 27, 29) to encode the CS, and a demux (Texas Instruments CD74HCT154M96) is used to generate the individual CS signals.
The 24 digital potentiometers are grouped in pairs that are daisy-chained. Need code that can set any of the 24 potentiometer values and reads any of the 24 ADC channels.
See attached connections details and starter code.
ID projekta: #19334013
Več o projektu
6 freelancerjev ponuja v povprečju za $239 na tem delu
Hi I am experienced electronics engineer with more than 8 years of experience. I can do it for you. Please review my profile to see the feedback from my previous employer. I am waiting for your reply to start Re Več
Dear sir I have more than 10 years experience in embedded systems design , I can make the required design to read from the ADCs and adjust the frequency potentiometers Best regards
Hi, I am kahan. I am embedded developer and have much experienced in hardware and software side. Waiting for further discussion. Thank you.
Hi, I would love to design this project for you as I have more than 15 years experience in embedded systems design and development. Please contact. regards, Ali
Hello , it’s so easy for me and I would like to help you! I have experience more than 4 years in embedded development, can we discuss about project?