Arduino Dw1000 proximetry sensor

Arduino Dw1000 proximetry sensor I am looking for a freelancer who can assist me with developing a software for an Arduino Dw1000 proximetry sensor. The following are my project requirements: - The desired range of the sensor is up to 10 meters. - I require assistance with developing the software for the sensor. - The preferred programming language for the software is C++. Ideal skills and experience for this project include: - Proficiency in C++ programming language - Experience in developing software for Arduino boards - Knowledge of the Dw1000 proximetry sensor. #include <DW1000.h> #include <DW1000Ranging.h> #include <WiFi.h> // WiFi credentials const char* ssid = "YourWiFiSSID"; const char* password = "YourWiFiPassword"; // DW1000 module pins #define DW1000_RST_PIN 4 #define DW1000_IRQ_PIN 16 #define DW1000_SCK_PIN 18 #define DW1000_MISO_PIN 19 #define DW1000_MOSI_PIN 23 #define DW1000_SS_PIN 5 // Threshold distance for proximity sensing #define PROXIMITY_THRESHOLD 914 // 30 feet in centimeters // GPIO pin for PWM output const int PWM_PIN = 12; // PWM settings const int PWM_FREQ = 1000; // Frequency in Hz const int PWM_RESOLUTION = 8; // Resolution in bits // WiFi client to send proximity data to a server WiFiClient client; void setup() { [login to view URL](115200); // Connect to WiFi [login to view URL](ssid, password); while ([login to view URL]() != WL_CONNECTED) { delay(1000); [login to view URL]("Connecting to WiFi..."); } [login to view URL]("WiFi connected"); // Initialize the DW1000 module [login to view URL](DW1000_RST_PIN, DW1000_IRQ_PIN, DW1000_SCK_PIN, DW1000_MISO_PIN, DW1000_MOSI_PIN, DW1000_SS_PIN); // Setup the DW1000 ranging module [login to view URL](DW1000.MODE_SHORTDATA_FAST_ACCURACY); // Setup PWM pin ledcSetup(0, PWM_FREQ, PWM_RESOLUTION); ledcAttachPin(PWM_PIN, 0); [login to view URL]("Proximity sensor started"); } void loop() { // Get the distance measurement from the DW1000 module [login to view URL](); delay(10); if ([login to view URL]()) { double distance = [login to view URL](); [login to view URL]("Distance: "); [login to view URL](distance); [login to view URL](" cm"); // Send proximity data to a server if (distance < PROXIMITY_THRESHOLD) { if ([login to view URL]("[login to view URL]", 80)) { String postData = "distance=" + String(distance); [login to view URL]("POST /proximity HTTP/1.1"); [login to view URL]("Host: [login to view URL]"); [login to view URL]("Content-Type: application/x-www-form-urlencoded"); [login to view URL]("Content-Length: "); [login to view URL]([login to view URL]()); [login to view URL](); [login to view URL](postData); [login to view URL](); [login to view URL]("Proximity data sent"); [login to view URL](); // Start PWM on GPIO pin ledcWrite(0, 255); // Set PWM duty cycle to maximum (255) } else { [login to view URL]("Failed to connect to the server"); } } else { // Stop PWM on GPIO pin ledcWrite(0, 0); // Set PWM duty cycle to 0 } } delay(1000); // Wait for 1 second before the next measurement }