18/05203/FUL | Part demolition, partial retention of the front elevation and a rebuild of the site for the conversion of 1 residential unit at first and second floors into 4 self-contained units: 1 x 1bed and 3x 2bed units involving the demolition of the existing first floor storage room and the erection of a rear extension at first and second levels and two additional storeys including the formation of a lightwell together with fenestrations alterations at the front elevation and the relocation of a rear extraction flue and staircase serving the existing commercial unit and the provision of cycle and refuse storages at ground level. A replacement shop front and the relocation of an existing front main entrance to the residential units. | 48 Kennington Road London SE1 7BL
Need structural engineer to review housing plans that involve, Insulated Concrete Forms- Concrete footings, for rebar reinforcement, possible Helix Micro Rebar prescriptive method. Roofing Rafters, Roof sheathing, LVL and of lap slicing of long lumber runs. Engineering must be quoted, and final engineering stamped by licensed engineer in the state of Maryland.
To review and seal the site plan and floor plan for a temporary structure (Tent) in Ontario, Canada. Several locations in Ontario. Also have structural drawings to review and seal. Must be architect that is registered in Ontario, Canada.
I have my house sold if I can get a structural engineer vervaction with plans ( I have plans that have been drawn up by architect) but don't have the stamp required by permit department this addition was built over 18 years ago labor and industry has signed of there part as it is a manufactured home, I have to have this done by end of next week so as not to lose buyers. My husband is got advanced cancer and his living past 9 months is dependent on me moving him to Oklahoma so as to get the treatment he needs and so I also will have family support so as not to have to go thru this all alone. Thank you for any help possible Cherir hovik
A total of 4 apartment buildings, 2 with 98 units each and 2 with 99 units each. Multiple apartment unit types as outlined in the attached PDF's. Need Mechanical, Electrical, Plumbing and Fire Sprinkler engineering design fees and timeline.
1120م2 السلام عليكم ورحمة الله، مطلوب مهندس لتصميم مخططات إنشائية وإلكتروميكانيكال حسب الكود السعودي، المشروع عبارة عن مشروع تجاري مكتبي بطابقين بمساحة 1890م2، مساحة المسطح
We are applying to extend our home and need to satisfy the requirements of the local conservation authority. To do this, a topographic survey or grading plan prepared by a qualified professional (P.Eng. or OLS) demonstrating that flood depths do not exceed 0.8m needs to be provided. We have measured and know that we satisfy their requirements, but aren’t licensed to do the actual surveying, so we need to hire someone to come out and do this and sign off on it. The area we’re looking to add an addition to is less than 100 square feet. Located in GTHA
I am looking for an architect to draw up plans for council submission in Rockhampton. I am a pensioner with limited funds. I have attached what I want the house to look like, want it to be a 4 x 2 with the kitchen to be indoor/outdoor, have a surround verandah. Building with sea containers, 2 stacks of 2, bottom 2 will be workshops, the top 2 will be the house with a span of 3 mtrs between the containers. The dimesions of the sea container would make the depth 18mtrs including the verandah, the width can only be 17mtrs, as the block is only 20mtrs wide. The verandah would act as a carport. The other version would be using 2 sea containers and building up the soil to be above flood level.